Table of Contents
Advertisement
Other functions of RDR Utility
<Commands for physical disks>
Remove Physical Disk from RDR Virtual Disk
All data including RDR settings on a physical disk can be deleted.
IMPORTANT:
After executing the command, the physical disk becomes an empty basic disk without RDR
settings.
This command can only be executed to physical disks in Duplex/Syncing state.
1.
Start RDR Utility and right-click a target disk on the tree in the left pane, and click [Remove
Physical Disk from RDR Virtual Disk].
2.
In the [Warning] dialog box, click [Yes].
3.
In the [Success] dialog box, click [OK].
Clear MTBF
When a failure occurs to a disk, the mean time between failures (MTBF) is counted and the value is
saved. In RDR Utility, the value is displayed at [MTBF: Current] and [MtbfThresholdStatus].
These MTBF values can be cleared by the [Clear MTBF] command.
1.
Start RDR Utility and right-click a target disk on the tree in the left pane, and click [Clear
MTBF].
2.
In the [Success] dialog box, click [OK].
Windows Setup and Operation
3-25
Advertisement
Table of Contents
