Battery Installation; Remote Control Precautions; Operating Range For Wireless Remote Control - NEC M230X User Manual

Battery Installation

1
Press firmly and slide the battery
cover off.

Remote Control Precautions

• Handle the remote control carefully.
• If the remote control gets wet, wipe it dry immediately.
• Avoid excessive heat and humidity.
• Do not short, heat, or take apart batteries.
• Do not throw batteries into fire.
• If you will not be using the remote control for a long time, remove the batteries.
• Ensure that you have the batteries' polarity (+/−) aligned correctly.
• Do not use new and old batteries together, or use different types of batteries together.
• Dispose of used batteries according to your local regulations.

Operating Range for Wireless Remote Control

Remote control
Remote control
• The infrared signal operates by line-of-sight up to a distance of about 22 feet/7 m and within a 60-degree angle of
the remote sensor on the projector cabinet.
• The projector will not respond if there are objects between the remote control and the sensor, or if strong light falls
on the sensor. Weak batteries will also prevent the remote control from properly operating the projector.
2
Install new batteries (AAA). Ensure
that you have the batteries' polarity
(+/−) aligned correctly.
7 m/22 feet
30°
30°
Remote sensor on projector cabinet
30°
30°
7 m/22 feet
11
1. Introduction
3
Slip the cover back over the bat-
teries until it snaps into place. Do
not mix different types of batteries
or new and old batteries.
TIP:
Short-throw model (M350XS/M300XS/
M260XS/M300WS/M260WS):
The front remote sensor is located on the
front left of the cabinet.