Attaching The Ferrite Cores - NEC PlasmaSync 42PD3 User Manual

Appendix
Attach the ferrite cores to the power cable and the DVI signal cable.
Use of the cables without mounting the ferrite cores will result in the occurrence of noise.
Power cable
Open the ferrite cores and clamp them on
1
the power cable.
Ferrite core
Close the ferrite cores.
2
Attach the large ferrite core at the end of the power cable that is close to the monitor.
Attach one small ferrite core to each end of the DVI signal cable.
Power cable
To power outlet
DVI signal cable
Ferrite core (Small)
To equipment with a
digital interface
50
P M
LASMA ONITOR
†

Attaching the Ferrite Cores

Power cable
Mounting Positions of Ferrite Cores and Cable Ties
Ferrite core (Large)
Cable tie
DVI signal cable
Open the ferrite cores and clamp them on
1
the DVI signal cable.
Ferrite core
Close the ferrite cores.
2
Fix the ferrite cores in place with cable ties
3
so that they do not shift.
Cable tie
Ferrite core (Large)
Ferrite core (Small)
Cable tie
DVI signal cable
To AC IN connector of monitor
To the RGB 3 connector
of this monitor