Table of Contents
Advertisement
2. Using the bracket as a guide, drill pilot holes into the
wall/floor. It is recommended to secure the bracket
to as many floor joists and wall studs as possible.
ANTI-TIP BR ACKE T INS TALL ATION
3. Using the provided screws and washers, secure the
KIT CONTENTS
bracket to the wall/floor. Adjust the rear rollers to
• (1) One anti-tip bracket
just above their lowest position and move the unit to
its final position. Raise the rear rollers a minimum
• (4) Four 3 ⁄16" masonry screws
of 1/8" to engage the bracket.
• (8) Eight #12-2" wood screws
• (12) Twelve 1/4" washers
REQUIRED TOOLS
• Tape measure
• Marking utensil
• 1/8" drill bit
• 7/16" socket
• Phillips bit driver
• Drill or ratchet
WARNING! TIP OVER HAZARD.
hazard from appliance instability, install
the anti-tip bracket in accordance with
the instructions below.
BEFORE YOU BEGIN
Consult a flooring expert to confirm that the flooring
where the unit will be installed is rated for at least 150
pounds per square foot.
C L
TEC_TM_065 REV. B
FIGURE 1.1 - ANTI-TIP BRACKET
To avoid a
TR-30REF-R-SG-A
N O T E : D I M E N S I O N S M AY VA R Y B Y ±
9 9/32"
236mm
C L
FLUSH INSTALL
I N S T A L L A T I O N
PROCEDURE
1. Measure and mark the depth of the bracket's
placement in the installation location.
• Flush installation: 24-31/32" (634 mm)
• Proud installation: 22-31/32" (584 mm)
2. Place and center the bracket at the measured
depth.
3. With the bracket as a guide, drill pilot holes into
the wall and/or floor.
NOTE: FOR INCREASED STABILITY, SECURE THE
BRACKET TO AS MANY JOISTS AND/OR STUDS AS
POSSIBLE.
4. With the provided hardware, secure the anti-tip
bracket.
5. Adjust the rear leveling rollers 1/4 turn clockwise.
6. Slide the unit into place and hook the anti-tip
bracket into the castor assembly slots.
/
"
1
8
24 31/32"
634mm
03/31/2022
T RUE 42 /4 8 IN STA L L M A NUA L
Page 23 of 48
Advertisement
Table of Contents
