US Robotics MAXg User Manual page 88

Wireless MAXg Access Point User Guide
power and status LEDs. Verify that the device is powered on and connected to the
Internet. Refer to the device's documentation for information on its status
indicators.
2. If the access point is configured to get an IP address dynamically, make sure that
the networking device has a DHCP server running.
3. If the access point is connected directly to your modem, check the modem
documentation to determine whether the access point needs to have a static IP,
gateway, and DNS entries or will get the network address using DHCP; then make
sure that the access point is configured accordingly.
4. Ping the router or other networking device. If the ping returns a reply, the access
point is reaching the networking device. Refer to the device's documentation for
debugging the connection between the device and your Internet Service Provider.
Return to Troubleshooting page
© 2007 U.S. Robotics Corporation
file:///G|/CSO/T-Writer%20Repository/Networking/5455%...%20CR%20AP/Regulatory%20Preview/trouble_internet.html (3 of 3)4/24/2007 5:15:57 PM