Table of Contents
Advertisement
Pau ing Program Execution
You can specify where execution of a program should pause by including either a Pau e
command or a Wait command inside the program.
U ing the Pau e Command
A Pau e command causes program execution to pause when it reaches that point. To
resume program execution, tap the
also cause the button to disappear).
Example
U ing the Wait Command
The syntax of the Wait command is: Wait <seconds>. When program execution reaches
the Wait command, it pauses for the specified number of seconds and then resumes
automatically. If you do not specify a value for the number of seconds, execution remains
paused until you tap the screen or press a key.
Tip
• To input the Pau e or Wait command, tap [Ctrl] on the menu bar, tap [Control], and then select
the command you want.
Terminating Program Execution
Pressing
while a program is running terminates the program.
Tip
• Pressing
does not terminate the program if program execution is already paused by the
Pau e command (indicated by
execution, and then press
12-2-6
Creating a New Program
button on the right side of the status bar (which will
on the status bar). In this case, tap
.
20060301
to resume program
Advertisement
Table of Contents
