Table of Contents
Advertisement
Programming Instructions
Command
:OUTPut[n][:CHANnel[m]
:POWer:UNit/?
[:STATe]/?
[:SOURce[n]][:CHANnel[m]]:POWer
[:LEVel][:IMMediate][:AMPLitude]/? Sets or returns the laser output power.
:STATe/?
:UNIT/?
[:SOURce[n]][:CHANnel[m]]:WAVelength
[:CW|:FIXED]/?
:TOGRid
:AUTO/?
52
Summary
• This chapter refers to both the 81950A module and the
N7711A/N7714A instruments. The N771xA command set is derived
from the 8163A/B, 8164A/B, and 8166A/B command set.
• Please refer to the Agilent 8163A/B, 8164A/B, 8166A/B Programming
Guide for an introduction to programming instruments and for
information about programming and syntax conventions. If you are
using an 8163B or 8164B with LAN support please also refer to the
Agilent 8163B Lightwave Multimeter, Agilent 8164B Lightwave
Measurement System LAN Interface Addendum to the User and
Programming Guides.
• An "X" in the "New" column in the table below means that the
command was not implemented in previous instruments and is not yet
described in another manual.
• Source specific commands not listed in the table below are not
supported.
• The "[:CHANnel[m]]" part means the channel (i.e. sub-module) of a
module in a modular instrument like the 8163A/B, 8164A/B, 8166A/B
platform. The 81950A module and the N7711A, N7714A instruments
accept only ":CHANnel1" which is the default anyway, so this optional
part can be omitted.
Description
Sets or returns the power unit used (dBm or W).
Sets a source's output state or returns its current state.
Sets or returns the state of the source output signal.
Sets or returns the power unit.
Sets or returns the wavelength of a source.
Sets the wavelength to the nearest grid point, only chang-
ing the channel number.
Sets auto mode on or off or returns its current state.
X
X
Agilent 81950A Compact TLS module, First Edition
Summary
New
Page
page 54
page 54
page 56
page 57
page 57
page 59
page 60
page 60
Advertisement
Table of Contents
