Miele KM 93-2 Operating Instructions Manual page 23

Installation instructions
2 zone Combiset
1 Combiset
2 Combisets
3 Combisets
4 Combisets
5 Combisets
4 zone Combiset
1 Combiset
2 Combisets
3 Combisets
Combination
One 2 zone
+ one 4 zone
Two 2 zone
+ one 4 zone
Three 2 zone
+ one 4 zone
One 2 zone
+ two 4 zone
Two 2 zone
+ two 4 zone
Extractor (e.g. DA 8-2)
For building in between two appliances:
- Dimension B increases by 3 9/16".
For building in at the end of a combination:
- Dimension B increases by 3 7/8".
* Width includes provision for V 98 spacer bar
Place the seal provided
edge of the cooktop.
Depth Width *
in (= Dimen-
inch sion B)
in inch
19-5/16" 10-7/16"
19-5/16" 22"
19-5/16" 33-1/2"
19-5/16" 45-1/32"
19-5/16" 56-9/16"
19-5/16" 22"
19-5/16" 45"
19-5/16" 68"
19-5/16" 33-1/2"
19-5/16" 45"
19-5/16" 56-9/16"
19-5/16" 56-1/2"
19-5/16" 68-1/16"
.
f
under the
Installation instructions
loosen
b
Appliance
c
Tensioning screw
d
Clamp
e
Countertop
f
Seal
Turn the tensioning screws
counter-clockwise until a resistance
is felt, then turn the clamp to the left.
Place the appliance into position,
turn the clamps and tighten the ten-
sioning screws until the clamps
press into the countertop
Install the stainless steel lid, EA 80 (if
applicable). It is supplied with its
own installation instructions.
Connect the appliance to the electri-
cal supply.
When installing several Combiset units,
a stainless steel spacer bar must be
placed between the units. It is supplied
with its own installation instructions.
tighten
c
e
.
23