Camera Mounting And Aiming; Reformatting The Micro Sd Card - Midland XTC-100 Owner's Manual

Camera Mounting and Aiming

Mount on Dual Track System
The XTC-100/150 was innovatively designed with an identical dual
track mount system on either side of the camera. This allows you to
mount it on both sides of a helmet with ease. In addition, the main mount
piece is interchangeable and can be moved from the helmet mount to
the goggle mount. This eliminates the hassle of having to remount the
camera every time.
To mount the camera on the main mount piece, slide the camera onto
the dual track system with the two notches on the mount facing towards
the back of the camera.
To detach the camera from the main mount, hold the camera with the
lens facing away from you. Press down the mount release switch and pull
the mount towards yourself.
Aiming the Camera when mounted with the dual track mount:
When mounting the camera on a helmet, you must do the following:
1. Consider what you would like to shoot and mount the camera
accordingly- left side, right side or top.
2. Find a flat surface and ensure the area is clean of dirt and debris.
Remove the cover of the adhesive pad and adhere to the helmet.
3. Once attached, adjust the camera to be sure you are not filming the
sky or the ground.
4
Mount using the Thread Mount
allows the camera to be mounted to a tripod or other fixture with a 1/4-
20 (1/4" diameter, 20 threads per inch) 5/16 deep thread. The vented
helmet strap mount is a screw type mount. To affix the camera, insert
the screw on the mount into the camera thread and rotate the camera
clockwise to tighten down onto the screw.
Dual Track
Mounting System
Mount Release
Switch
Aiming the Camera when mounted with the thread mount:
Interchangeable
When mounting the camera on the handlebars of a bike or with the
Mount
1. Consider what you would like to shoot and mount accordingly.
2. Ensure once attached that the camera is aimed straight and not
The Micro SD card can be reformatted while in the camera. This allows you
1. Move the RECORD switch to the record position.
2. When the battery indicator turns green, press and hold the
3. Keep the Micro SD card reformat button down until the record indicator
4. Move the RECORD switch to the off position.
www.midxtc.com
Camera Mounting and Aiming
On the bottom of the XTC-100/150 is a standard thread mount that
Over tightening may cause damage
to the mount and/or camera
Thread Mount
Screw Mount
vented helmet strap mount follow these steps:
towards the ground or at the sky.

Reformatting the Micro SD card

Ensure batteries are new or fully charged before formatting
to delete all the videos at one time. Follow these steps:
Micro SD card reformat button.
turns off and the SD card indicator begins blinking green.
Note: The camera cannot reformat the Micro SD card if the low
battery light is on.