Getting To Know The Xtc-200; Battery; Micro Sd Card; Recording - Midland XTC-200 Owner's Manual

Getting to Know the XTC-200

Battery

1. To insert the battery, push down the battery door latch on the right side of
the camera. Door will release. Push forward to remove.
2. Install Lithium-Ion battery.
3. Return battery door and click into place.
Battery Status
Indicator
Solid Green
Blinking Green
Solid Red
Blinking Red*
No Light
*Note: When the red battery LED begins blinking, be prepared
to charge the battery because the camera will stop recording
at this point.

Micro SD Card

1. Open and fold down the back rubber cover.
2. Insert Micro SD card into slot observing proper direction (shown below).
3. Return rubber flap into place.
Meaning
Indicates full battery life
Battery is charging
Indicates half battery life
Indicates low battery life
Battery is dead
www.midXTC.com
Getting to Know the XTC-200

Recording

1. Move the RECORD switch forward. This turns the camera on.
2. The battery indicator will light from red to green. The SD card
indicator will light green. The record indictor will begin flashing
red after 8 seconds. This indicates the camera is capturing
video.
3. To stop recording, move the RECORD switch back to the
off position.
Note: The camera will continue recording for 3 seconds after
toggling the switch to the off position.
SD card LED
Status
Green 100% - 33% available.
Orange 33% - 20% available.
Red
no Micro SD card installed.
Flashing Red Cannot read the card.
Indicates card has been
Flashing Green
Memory Size HD Record Time SD Record Time
512 MB 6.5 Minutes
1 GB 13 Minutes
2 GB 26 Minutes
4 GB 52 Minutes
8 GB 104 Minutes
16 GB 208 Minutes
32 GB 416 Minutes
Note: The camera automatically splits the video into 2 GB segments.
Meaning
20% available or
reformatted.
9.5 Minutes
19 Minutes
38 Minutes
76 Minutes
152 Minutes
304 Minutes
608 Minutes
3