Entering Network Information - IBM Proventia Management SiteProtector SP1001 Hardware Configuration Manual

Entering Network Information

Procedure
1. Locate the LCD panel at the front of the SiteProtector SP1001 appliance, and
2. Press the ENTER button. The Appliance PIN screen appears.
3. Press the DOWN button.
4. When the message appears asking you to confirm that you want to change
5. Is the default IP address correct?
6. Select OK, and then press the ENTER button to confirm.
7. Repeat Steps 4 through 6 to enter the following information:
8. Select OK, and then press ENTER to confirm. The SiteProtector SP1001
16
SiteProtector System: SP1001 Hardware Configuration
Use this button...
then make sure that "IBM ISS Proventia SP1001" appears on the screen.
Note: If you want to require that users enter a personal identification number
(PIN) to use the LCD panel, see."Securing the SiteProtector SP1001 Appliance
Hardware" on page 28.
your configuration, select OK, and then press ENTER. A default IP address
appears.
v If yes, return to the configuration menu, and then go to Step 7.
v If no, enter the IP address of the SiteProtector SP1001 appliance in the field
provided.
Note: Press UP or DOWN to select a number, and then use the LEFT or
RIGHT buttons to move to another digit.
v subnet mask
v default gateway
v DNS Server
v hostname
Note: The SiteProtector SP1001 appliance provides a default subnet mask and
gateway address that is based on the IP address that you enter. You can skip
the procedure for entering these addresses if you verify that the default
gateway and subnet addresses are correct. See "SiteProtector SP1001 Appliance
Configuration Checklist" on page 12.
A final confirmation screen appears.
Note: If you want the SiteProtector SP1001 appliance to ignore the information
that you have entered, select Cancel, and then press ENTER.
appliance saves the configuration information you entered.
To do this...
Move down or specify digits. Referred to as
the DOWN button.
Move up or specify digits. Referred to as the
UP button.
Enter information, or confirm a selection and
move to a new screen. Referred to as the
ENTER button.