Chapter 3. EXP3000 controls, LEDs, and power
This section describes the controls and light-emitting diodes (LEDs) and how to turn
the EXP3000 on and off.
Front view: components
The components on the front of the EXP3000 are shown in the following illustration.
Hot-swap hard disk drive
Filler panel
Bezel (left side)
© Copyright IBM Corp. 2007
Hot-swap hard disk drive
System Storage
You can install up to 12 hot-swap SAS or SATA hard disk drives in the
EXP3000.
The EXP3000 comes with filler panels in the drive bays. Before you install a
hard disk drive, remove the filler panel and save it for future use. Each of
the 12 drive bays must contain either a filler panel or a hard disk drive.
The left bezel contains the EXP3000 LEDs, as shown in the following
illustration. For a description of the LEDs, see "Front view: LEDs" on page
18.
Power-on LED
System locator LED
Overtemperature LED
System error LED
Filler panel
Bezels
17