Checking the chain brake
Do not work with the chain saw without first checking the
chain brake!
-
Start the engine as described (make sure you have a good
footing, and place the chain saw on the ground in such a
way that the guide bar is free of contact).
-
Grasp the tubular handle firmly with one hand and hold the
grip with the other.
-
With the engine running at moderate speed, press the hand
guard (C/1) in the direction of the arrow with the back of
your hand until the chain brake engages. The chain should
stop immediately.
-
Immediately release the throttle and release the chain
brake.
IMPORTANT: If the chain does not stop immediately when
you test the chain brake, do NOT use the chain saw. Take
the chain saw to a MAKITA service center for repair.
Adjusting the carburetor
24