Mackie PPM1008 Owner's Manual page 9

Microphones
press HI-Z
buttons
Adjust
Vocal
Compression
Send
Return
Guitar Processor
(connected to INSERT)
Keyboards
Electronic Drum Kit
This diagram shows microphones attached to the mic inputs of channels 1 to 4, electric guitars
connected directly to ch. 5 and 6 (with hi-z switches pressed in), a guitar processor connected to ch.6
insert, a keyboard attached to channel 7's stereo inputs, and an electronic drum kit attached to channel
8. Add vocal compression as required, by tweaking the compression knobs on channels 1 to 4.
The power amp mode switch is set to play the monitor 1 mix on channel A, and monitor 2 mix on
channel B. Note: Press in the front panel FX send/mon 2 send switch, or monitor 2 will not play.
C200 passive stage monitors are connected to the channel B speaker-level power output of the
powered mixer. These play the stage monitor mix 2 to your performers. C300z passive stage monitors
are connected to the channel A speaker-level power output, and play stage monitor mix 1.
Mackie HD1531 powered speakers and HD1801 powered subwoofers are connected to the line-level
main mix outputs, and play the stereo main mix to your audience.
Front Panel
HD1531
Powered
Speaker
HD1801
Powered Subwoofer Powered Subwoofer
(plays right main mix) (plays left main mix)
Large Band System
Power Amp Mode
switch set to
Mon 1/Mon 2
HD1531
Powered
Speaker
C200 Passive Stage Monitors
(plays mon 2 output)
C300z Passive Stage Monitors
(plays mon 1 output)
HD1801
Owner's Manual
Rear Panel
9