AGFA DRY 1.4 User Manual page 31

Transporting the printer
1. Switch off the printer.
2. Disconnect the cables.
3. Move the printer to its destination (with 2, preferably 3 persons!).
4. Reconnect the cables.
5. Switch the printer on.
1
Lift printer from pallet with 3 persons.
2
If only 2 persons are available, lift as
shown below.
3
Put printer on a table. Always put tray
side at front.
Figure 2: Transport possibilities
DRY 1.4, DRY 2.4 | Introduction | 31
2
If only 2 persons are available, li
shown below.
3631B EN 20210601 1655