Cisco NCS 540 Installation Manual page 48

Small density passive cooled routers

Hide thumbs Also See for NCS 540:

Table of Contents

Install and Remove SFP and SFP+ Modules

Note

To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety, connect

the Management Ethernet ports only to intra-building or unexposed wiring or cable. The intrabuilding cable

must be shielded and the shield must be grounded at both ends. The intra-building port(s) of the equipment

or subassembly must not be metallically connected to interfaces that connect to the OSP or its wiring. These

interfaces are designed for use as intra-building interfaces only (Type 2 or Type 4 ports as described in

GR-1089-CORE) and require isolation from the exposed OSP cabling. The addition of Primary Protectors is

not sufficient protection in order to connect these interfaces metallically to OSP wiring.

Install and Remove SFP and SFP+ Modules

The router supports a variety of SFP and SFP+ modules, including optical and Ethernet modules. For

information on how to install and remove SFP and SFP+ modules, see the documentation for the SFP or SFP+

module at:

http://www.cisco.com/en/US/partner/products/hw/modules/ps5455/prod_installation_guides_list.html

For information about inspecting and cleaning fiber-optic connections see,

partner/tech/tk482/tk876/technologies_white_paper09186a0080254eba.shtml

Caution

We recommend that you wait for 30 seconds between the removal and insertion of an SFP on an interface

module. We recommend this to allow the transceiver software to initialize and synchronize with the router.

Changing an SFP more quickly could result in transceiver initialization issues that disable the SFP.

Connect a USB Flash Device

To connect a USB flash device to the router, remove the dust cap and insert the memory stick in the USB port

labeled USB MEM.

Note

Retain the dust caps for later use.

The Flash memory module can be inserted only one way, and can be inserted or removed regardless of whether

the router is powered up or not.

Figure below shows the USB port connector on the router.

Figure 20: Router Flash Token Memory Stick

Cisco Network Convergence System 540 Passive Cooled Small Density Routers Hardware Installation Guide

Install the Cisco N540-6Z14S-SYS-D Routers

http://www.cisco.com/en/US/

Table of Contents