Advertisement
will appear on the display and blink.
3.
Wait a few seconds until the unit is automatically paired to the external BT Device.
The indicator "
4.
After pairing is complete you may now play music with your external BT Device.
FM RADIO:
1.
Power on the unit as previously instructed.
2.
Press the MODE Button on the Unit or Remote Control repeatedly indicator
Radio frequency "XX.X MHz" will appear on the display.
3.
To store the available FM stations into the unit at first time use (or relocate the
unit to a new location):
Press the ►II/SCAN Button on the unit or Remote Control. FM frequency on
the display will start running.
Wait a few minutes, the unit will automatically store all the available FM
stations into the memory then playback the first station.
Long press the I◄◄ or ►►I buttons on the unit or Remote Control repeatedly
4.
to select and play the stored FM station as desired.
If reception is weak, short press the I◄◄ or ►►I buttons on the unit or Remote
5.
Control repeatedly to select and play the stored FM station as desired.
Antennas:
This unit has a FM wire antenna on the rear of unit, which provides adequate reception
in most areas. If reception is weak, unwind and extended to its full length and/or
reassemble the other direction/location to improve the reception.
AUX (AUX/LINE IN):
Listen from an external Audio Player such as a Cell phone, MP3 Player, Discman ...etc.
1.
Connect one end of the Audio Connection Cable (included) to the AUX Out/Line
Out/Phone Jack on the external Audio Player.
2.
Connect the other end of the cable to the AUX (Aux/Line In) Jack on the rear of
unit as illustrated below:
3.
Power on the unit as previously instructed.
4.
Press the MODE Button on the Unit or Remote Control repeatedly until "
appear on the display.
5.
Play the music on the connected Player as usual. (Make sure the volume level of
bt
" on the display will stop blinking.
13
AUH
"
Advertisement
