Tape Dubbing Or Editing - JVC VideoMovie GR-A30 Instructions Manual

OPERATION
How to affix the matching transformer to your VHF antenna cable
Viewing video cassettes being
played back with the GR·
A30U
•If your VHF antenna cable is a 300-ohm
flat feeder, connect the two lugs to the
screws in an ordinary manner.
•If your VHF antenna cable is a 75-ohm coaxial cable, proceed as follows:
To view video cassettes or to
monitor the recording, set the
VIDEO/TV switch of the RF
channel selector to the chan-
nel corresponding to the RF
output channel (3 or 4).
Viewing television programs
Set the VIDEO/TV switch to
TV, and the TV receiver will
function as usual.
CD
Press both side tabs inward and slide the cover off.
® Strip the coaxial cable with a pair of wire strippers, a
knife, or the like as shown.
@ Remove the collar and put it on the pole inside the cover.
© Loosen the screws for the clamp and insert the stripped
cable so that the braided portion is positioned under the
clamp.
@ Insert the stripped end (core conductor) of the cable from
above into between the knife contacts.
@ Tighten the screws.
CD Replace the cover.
D
To A/V input
terminal
VC-V826U ,.,
A/V output cable ~
(optional)
To AV OUT
connector
Screws Knife contacts
Clamp Collar
•Simply connect the AV OUT connector of the GR·
A30U to the VIDEO and AUDIO IN connectors of
the television using the optional VC-V826U A/V
output cable.
•The optional VC-V826U A/V output cable can be
extended by 5 m ( 16 ft) with the optional VC-P1 U
A/V extension cable.
•Use the VIDEO (or A/V) mode specified on the
television, instead of tuning to channel 3 or 4.
TAPE DUBBING OR EDITING
Dubbing onto a standard recorder
Connection
1. Connect the AV OUT connector of the GR-A30U to the AUD IO and VIDEO IN connectors of the video
recorder using the optional VC-V826U A/V output cable.
2. Connect a television to the video recorder using the optional VC-V826U A/V output cable.
Operation
To AV OUT
connector
rn m~mm
VC-V826U
A/ V output cable
(optional)
@"
To VIDEO IN
and AUDIO IN
connectors
lD
•Put the G R·A30U in the Play mode and the connected recorder in the Record mode to copy the recording. To
edit out unwanted material, press the recorder' s PAUSE button.
1!