Advertisement
Configure eth1 from the NETWORK
CONFIGURATION screen
The configuration of NIC Ethernet 1 (eth1) applies
to the router. Normally, eth1 is preconfigured, but if
you have to configure it, use the following procedure.
At most, you should only have to configure eth1
once. Configure eth1 at the NETWORK
CONFIGURATION screen:
1. At the setup menu (Figure 4 on page 4), use the
key to move the cursor to Network
TAB
Configuration.
2. Press
. The NETWORK
ENTER
CONFIGURATION screen displays (Figure 7).
Note:
The bottom of the NETWORK
CONFIGURATION screen shows the navigation
commands. The most commonly used commands
are
, +, and ^
(
TAB
Q
simultaneously). The ^
steps the display back through the program.
3. Use the
key to move the cursor to eth0.
TAB
4. Press the down arrow key to move the cursor to
eth1.
Figure 7: Sample NETWORK CONFIGURATION screen for eth1
3270 3319 Rev B
key and
key pressed
CTRL
Q
(return) command
Q
5. Use the
key to move the cursor to the IP
TAB
Address field in the IP Configuration column.
6. Type the IP address that the manufacturer used
to configure the router. Or, use the screen
default.
7. Press the
key to move the cursor to the
TAB
Network field in the IP Configuration column.
8. Type the same address that you entered in the
IP Address field, but substitute a 0 for the last
number.
9. Press the
key to move the cursor to the
TAB
Network Mask field in the IP Configuration
column.
10. Type the address that you received from the
network administrator.
11. Press the
key to move the cursor to the
TAB
Broadcast field in the IP Configuration column.
12. Type the same address that you entered in the
IP Address field, but substitute 255 for the last
number.
13. Use the ^
command to return to the setup
Q
menu (Figure 4 on page 4).
14. Go to Configure arc0 from the NETWORK
CONFIGURATION screen on page 7.
6
Advertisement
