Table of Contents
Advertisement
Initial Use
2. Place the battery pack
device
. The green charging control LED
O
tinquishes and the red charging control LED
now glowing, indicates the start of the charging
process. The red charging control LED
guishes as soon as the battery pack
charged.
3. The green charging control LED
charging is complete and the rechargeable battery
pack
is ready for use.
Y
4. Disconnect the mains plug of the fast charging
device
from the socket.
O
Remove the rechargeable battery pack
j
A rechargeable battery pack
charged up a second time immediately after the
fast charging procedure. Otherwise there is a
danger that the rechargeable battery pack
be overcharged, thus reducing the lifetime of the
rechargeable battery pack
device
.
O
j
The charging device should be switched off for
at least 15 minutes between charging.
Please remove the mains plug.
Inserting and Removing the
L
Rechargeable Battery Pack
from the Device
Inserting the Rechargeable Battery Pack:
j
Please move the direction of rotation switch
to the "lock" position and allow the rechargeable
battery pack
to lock into place in the handle.
Y
Removing the Rechargeable Battery Pack:
j
Press the side release buttons
and remove the rechargeable battery pack
Torque Pre-selection
L
The rotary force can be adjusted by means of the
torque pre-selector
. The torque levels go up to
W
approximately 9 Nm.
Once the rotary force that has been set (markings
1-15) is reached, the clutch disconnects the drive.
8
GB/IE
in the fast charging
Y
ex-
P
,
{
extin-
{
is fully
Y
indicates that
P
.
Y
must never be
Y
will
Y
and the fast charging
Y
R
simultaneously
U
.
Y
j
Select a low level for small screws and soft ma-
terials.
j
Select a high level for large screws, hard materials
and when loosening screws.
j
If level 16 is selected, the clutch does not disconnect
the drive. The drive chain is locked in place. Select
this level if you require maximum rotary force.
Angular Position (Illustration A)
L
j
Press and hold the angular position switch
(see illustration A).
j
Move the device into the angular position
(no intermediate setting).
j
Release the angular position switch
Check whether the screwdriver has locked in
place in the angular position.
Changing the Tool
L
Inserting
j
Insert the bit into the tool holder
Removing
j
Remove the bit from the tool holder
Switching on / off
L
Notice: If the rotation direction switch
the central / neutral position, the ON / OFF switch
blocked. Therefore select a rotation direction before
switching on, in that the rotation direction switch
is pushed through completely
j
To switch the screwdriver on, press the ON / OFF
switch
and keep it pressed.
I
j
To switch the screwdriver off, release the ON / OFF
switch
.
I
Setting the Speed
L
The ON / OFF switch
has a variable speed control.
I
Increasing the Speed
j
Increase the pressure on the ON / OFF switch
E
.
E
.
Q
.
Q
is located in
R
is
I
R
.
I
Advertisement
Table of Contents
