Input Level Adjustment (Analog Sources Only); Adjusting The Sound - Kenwood VR-9060 Instruction Manual

Normal playback

Input level adjustment (analog sources only)

SOUND
MULTI %/ fi,
@/#
Input Selector
keys
Input level adjustment (analog sources only)
If the input level of an analog source signal is too high, the CLIP indicator
will light up to indicate the source signal. Adjust the input level.
L C
LFE
SL S SB
1 Use the INPUT SELECTOR key or Input Selector keys to select the
source of which the input level you want to adjust.
• You can store a separate input level for each input source.
2 For the remote control unit, press the RCV MODE key to switch
to the receiver mode.
3 Press the SOUND and 5/∞ keys or MULTI @/# keys repeatedly
until the "INPUT" indication appears.
4 Use the MULTI CONTROL knob or MULTI %/fi keys to adjust the
input level.
SP MUTE
A B CLIP
L C R
LFE
SL S SB SR
• The adjustment mode is displayed for approximately 20 seconds.
• The input level may be adjusted to any one of three settings:
0dB, -3dB, and -6dB. (The initial setting is 0dB.)
5 Press the SOUND key again to return to the input indication.
MULTI CONTROL
INPUT SELECTOR
SOUND
RCV MODE
SP MUTE
A B CLIP CLIP CLIP
R
SR
DOLBY PL II x

Adjusting the sound

ACTIVE EQ
LOUDNESS
PHONES BASS BOOST
TONE
BASS BOOST
MULTI %/ fi
RCV MODE
Adjusting the TONE
You can adjust the sound quality when the receiver is in the PCM stereo
and analog stereo mode.
1 For the remote control, press the RCV MODE key to switch to
receiver mode.
2 Press the TONE key to select the TONE mode.
3 Use the MULTI CONTROL knob or MULTI %/fi keys to select
TONE ON/OFF.
SP MUTE
A B CLIP
L C R
LFE
SL S SB SR
4 When in TONE ON selection, press the TONE key for the follow-
ing displays.
BASS : Select this to adjust the low frequency range.
TREBLE : Select this to adjust the high frequency range.
5 Use the MULTI CONTROL knob or MULTI %/fi keys to adjust the
sound quality.
SP MUTE
A B CLIP
L C R
LFE
SL S SB SR
• The bass and treble levels are adjustable from -10 to +10 in 2 step
increments.
• The adjustment item is displayed for approximately 20 seconds.
• This function is available only for speakers connected to FRONT A
terminals.
Adjusting the LOUDNESS mode
You can adjust the Loudness function which controls the low volume
settings to maintain the music's richness. The adjustment can be made
when the receiver is in the PCM stereo and analog stereo mode.
Press the LOUDNESS key to turn the LOUDNESS setting ON.
• This function is available only for speakers connected to FRONT A
terminals.
To cancel
Press the LOUDNESS key again so that the "LOUDNESS"
indicator goes off.
TONE MULTI CONTROL
VOLUME
CONTROL
MUTE
LOUDNESS
VOLUME%/fi
ACTIVE EQ
STEREO
STEREO
21 EN