Kenwood DV-5050M Instruction Manual page 63

c : To change a title
(Standard remote/Keyboard remote)
Operation procedure
1.
Make the unit ready for character input.
With the standard remote:
Perform steps 1 to 5 of "Assigning Title".
With the keyboard remote:
Perform steps 1 to 4 of "Assigning Title".
2.
Press the cursor left, right button to move the cursor
to the character to be changed.
3.
Enter the title name using the character input buttons.
÷ No character can be changed if 20 characters have
already been input. In this case, delete unnecessary
characters then enter the desired correction
characters.
÷ If the title to be changed is too long to be displayed
on the display section, press the cursor left/right
button to scroll the display so that the characters
hidden until then appear.
÷ A title name can be registered using up to 20
characters.
÷ If you commit a mistake in the character button
input, press the DELETE button and restart the
input from the beginning.
Standard remote
÷ If a desired character is not provided on the remote
control buttons, input the character as follows.
Press the CHARAC. 4, ¢ (down/up) buttons
or rotating the DISC knob on the main unit until
the desired character is displayed in the flashing
cursor position. Then, press the SET button.
÷ The type of characters (capital letters or numbers/
symbols) is switched each time the CHARAC.
button is pressed.
Keyboard remote (DV-5900M only)
÷ To input a symbol, press and hold the SHIFT
Πbutton while press the desired numeric/symbol
button.
„
4.
Press the ENTER button.
Chapter 6:Specifying and Using Disc or Track Data
d : To delete a title
(Standard remote/Keyboard remote)
Operation procedure
1.
Make the unit ready for character input.
With the standard remote:
Perform steps 1 to 5 of "Assigning Title".
With the keyboard remote:
Perform steps 1 to 4 of "Assigning Title".
2.
Press the cursor left, right button to move the cursor
to the character to be deleted.
3.
Press the DELETE button.
4.
Press the ENTER button.
Œ
„
63