JVC CA-NXF30 Instructions Manual page 59

Using the remote control for the
VCR operation
Before the VCR operation, select the remote
control mode for the VCR.
■ IMPORTANT
• Slide the remote control mode
selector to the lowest position.
1
Press [VCR].
2
Operate the remote control by
pointing it at the VCR.
Remote control button Usage
[DBS/VCR ]
F
[CH +/ ]
–
Number buttons
(1-10, 0, 10)
(playback)
3
7
8
y
1
[REC] + (playback)
3
[REC] +
8
NOTE
• When the remote control mode selector is slid to
the lowest position and [VCR] is pressed, some
buttons may not work.
• It is recommended that you slide the remote
control mode selector to [AUDIO] after using this
function. Most of the other functions can be used
when the remote control mode selector is at
[AUDIO].
Turns on/off the VCR.
Changes channels.
Selects the channels.
Starts playback.
Stops playback.
Pauses playback.
Fast-forwards the tape.
Fast-rewinds the tape.
Starts recording.
Pauses recording.
For the locations of the remote
control buttons, refer to page 53.
56