Playing Back Sources From External Devices Playing Back Sources From External Devices; Playing Back Sources From External Devices; Selecting The Signal Gain; Playback - JVC CA-NXF30 Instructions Manual

Playing back sources from external devices

■ IMPORTANT
• Slide the remote control mode
selector to [AUDIO].
Remote control
mode selector
Playing back sources from
external devices
1
Press [AUDIO IN] or [DIGITAL IN].
• [AUDIO IN] is for selecting the device
connected to the [AUDIO IN] terminals.
• [DIGITAL IN] is for selecting the device
connected to the [DIGITAL IN] terminal.
• You can also select the connected device as
the source by turning [SOURCE] on the
main unit.
2
Start playback on the connected
device.
3
Adjust the volume or the sound
quality for your preference.
• Refer to pages 12 to 14.
NOTE
• Refer also to the operation manual for the
connected device.
• You can also operate your digital broadcast
satellite and video cassette recorder using the
remote control of this system. Refer to pages 54
to 56.

Selecting the signal gain

You can select the gain of the signal from the
[AUDIO IN] terminals. Use the initial settings for
normal operation. If the sound is too small or too
loud, change the settings.
1
Press [AUDIO IN].
2
Hold down [ENTER].
• "LEVEL 1" or "LEVEL 2" appears in the
display window.
3
Press [ENTER] repeatedly to
select "LEVEL 1" or "LEVEL 2".
• Each time you press [ENTER], the display
toggles between "LEVEL 1" and "LEVEL 2".
• The signal gain in "LEVEL 1" is lower than
that in "LEVEL 2".
• The display returns to "AUDIO IN" in
approximately 5 seconds.
18