Battery Pack; Commissioning; Connecting A Device - Festool CLEANTEC CTLC SYS I Original Instructions Manual

English
7

Battery pack

Before using the battery pack, check that the
battery interface is clean. Any contamination of
the battery interface may impair correct contact
and lead to the contacts being damaged.
A faulty contact may result in the machine over­
heating or being damaged.
[2a]
Remove the battery pack.
[2b] Insert the battery pack – until it
clicks into place.
The cordless mobile dust extractor can
only be operated with two battery packs.
Compatible battery packs (see section 4).
Further information about the charger and
battery pack with capacity indicator can be
found in the corresponding operating
manual.
8

Commissioning

Standby mode
► Press the on/off button [1-14].
The green LEDs on the status display [1-12] in­
dicate standby mode.
Pressing the on/off button again will switch off
the cordless mobile dust extractor.
Starting/stopping the cordless mobile dust
extractor manually
The cordless mobile dust extractor is in standby
mode.
Directly on the cordless mobile dust extractor:
► Press the MAN button [1-13] to start/stop.
Alternatively, use the connected remote control
CT-F I (see chapter 9.2):
► Press the MAN button [1-18] on the remote
control to start/stop.
Starting/stopping the cordless mobile dust ex­
tractor automatically
The cordless mobile dust extractor is in standby
mode.
► To start/stop the cordless mobile dust ex­
tractor automatically: Switch the connected
battery-powered power tool on/off (see
chapter 9.1).
22
9

Connecting a device

WARNING
Risk of injury from a cordless mobile dust
extractor starting up unsupervised
► Before performing any work with the cord­
less mobile dust extractor, check which re­
mote control and which cordless power
tool are connected to the cordless mobile
dust extractor.
► A battery-powered power tool must always
be connected to the cordless mobile dust
extractor via the suction hose. After finish­
ing work, the connection to the cordless
mobile dust extractor must be disconnec­
ted.
► The remote control must only be attached
to the suction hose.
9.1 Connecting a battery-powered power
tool
► In standby mode, press the connection but­
ton [1-9].
The connection display [1-10] slowly flashes
blue. For a period of 60 seconds, the cordless
mobile dust extractor is ready for connection.
► Switch on the power tool.
The cordless mobile dust extractor starts up.
The cordless mobile dust extractor is connec­
ted until the on/off button [1-14] is pressed or a
battery pack is removed (from the cordless mo­
bile dust extractor). The power tool must then
be connected again.
Connecting a new power tool overwrites
the previous connection.
This function is only possible on Festool
power tools with a Bluetooth
pack.
9.2 Connecting the CT-F I remote control
To be able to connect a remote control to a
cordless mobile dust extractor, the remote con­
trol must be reset (see "Reset on the remote
control").
Remote controls that have not been connected
previously can be connected directly.
A connection that has been created be­
tween remote controls and the cordless
mobile dust extractor will persist even af­
ter pressing the on/off button or removing
a battery pack (from the cordless mobile
dust extractor).
®
battery