Basic Recording - JVC HR-XV48E Instructions Manual

Filename [XV48EX_EN_07S-VHS.fm]
XV48EX_EN_01.book Page 21 Saturday, October 9, 2004 10:34 PM

Basic Recording

Turn on the TV and select the video channel (or AV
mode).
Slide the TV/VCR/DVD switch on the remote
control to the right.
Slide to the
right.
A
Load a cassette.
Insert a cassette with the record safety tab intact.
The unit's power comes on automatically and the counter is
reset to 0:00:00.
B
Select the VHS deck.
On the unit
Press VCR/DVD repeatedly so that the VCR indicator
lights up.
On the remote control
Press VCR so that the VCR indicator lights up.
C
Choose a programme.
Press PR +/– or the number keys to select the channel
you wish to record.
Page 21
D
Set the tape speed.
Press p. The current setting appears on the front
display panel or TV screen. Press p again to change
the setting while the tape speed is displayed on the TV
screen.
E
Start recording.
Press and hold 7 and press 4 on the remote control, or
press 7 on the unit.
If "O.S.D." is set to "ON" ( pg. 53), "MARK" blinks on the
screen while an index code is being marked.
When "DIRECT REC" is set to "ON" (
any button just after pressing 7 on the unit (or 7 and 4 on
the remote control), the unit may not function properly.
B.E.S.T. works at the beginning of both the first SP and the
first LP recording after inserting the cassette. (
If "DIRECT REC" is set to "ON," the programme that appears
on the TV screen will be recorded. (
F
Pause/Resume recording.
Press 9. Press 4 to resume recording.
You can select channel during the Record Pause mode.
G
Stop recording.
Press 8. Then press x on the VHS deck to remove the
cassette.
Recording Resume Function
If there is a power outage during recording, Instant Timer
Recording, or timer recording (
recording will resume automatically when power is restored
to the unit unless the unit's memory backup has expired.
Accidental erasure
prevention
To prevent accidental recording
on a recorded cassette, remove its
safety tab. To record on it later,
cover the hole with adhesive tape.
NOTE:
When the end of the tape is reached during recording, the unit
stops and " " and "$" blink on the front display panel.
Masterpage:Right-No-Heading
21
EN
pg. 53), if you press
pg. 23)
pg. 53)
pg. 21, 22, 26), the
Record safety tab
October 9, 2004 10:34 pm