JVC DR-MV5SE Instructions Manual page 35

CANCEL
PROG
ENTER
When Programmes Overlap Each Other
If "PROGRAMME OVERLAPPED" appears, you have another
programme overlapping the programme you have just made.
Confirm with the arrow on "OK", then press PROG. The
Programme Check screen appears and conflicting programmes
will be highlighted in pink.
Example: Programme 3 (you
have just made) and
programme 4 overlap each
other.
1
Confirm the overlapping
programmes. Overlapping
programmes appear on the TV
screen.
NOTE:
If you do not mind this overlap, press PROG to finish the timer
programme setting. The programme whose start time is earlier will be
recorded and the other one will not be recorded correctly.
2
Press rt to select the desired programme to be cancelled or
changed.
If programme on the DVD deck and programme on VHS deck overlap
each other, mark appears on the left of the date of each item.
Press rt w e to select "VHS PRGM CHECK" or "DVD PRGM
CHECK", then select the programme to be cancelled or changed.
To cancel the programme
Press CANCEL.
"THE TIMER PROGRAMMING SETTING WAS CANCELLED"
appears on the TV screen for about 5 seconds, then the normal
screen resumes.
To change the programme setting
Press ENTER, then go to step 3.
3
Change the programme setting.
Refer to steps 5 – 10 in "Manual Timer Programming" (
4
Press PROG to check if the conflict has been settled. The
Programme Check screen appears.
5
Engage the unit's timer mode.
Refer to step 6 in "Check, Cancel And Change Programmes"
( pg. 34).
NOTE:
When any overlaps remain after deletion and modification of
programmes, the Programme Check screen remains showing the
conflicting programmes. In such a case, repeat the procedure above
until the conflict is solved.
TIMER RECORDING
35
EN
VHS PRGM CHECK DVD PRGM CHECK
DATE START-STOP TV PROG DAILY/WEEKLY VPS/PDC REC MODE
05/07 SAT 18:10-20:00 L-1 ON SP
06/01 THU 18:10-20:00 L-1 ON SP
10/07 THU 19:00-20:00 7 WEEKLY OFF XP
10/07 THU 19:45-20:30 7 OFF LP
+++++++++++++++++ DVD NEW TIMER PROGRAMME +++++++++++++++++
DISC TIMER PRGM
EXIT OK
SELECT WITH [CURSORS]
THEN PRESS [ENTER]
SELECT
PROG
pg. 31).