Power - JVC GR-D390EK Instructions Manual

GETTING STARTED
14
EN

Power

This camcorder's 2-way power supply system
lets you choose the most appropriate source of
power. Do not use provided power supply units
with other equipment.
Charging The Battery Pack
Battery pack mount
Battery pack
Arrow
To AC outlet
To DC
connector
AC Adapter (ex. AP-V17E
1
Set the Power Switch to "OFF".
2
With the arrow on the battery pack pointing
downward, push the battery pack slightly against
the battery pack mount a.
3
Slide down the battery pack until it locks in
place b.
4
Connect the AC Adapter to the camcorder.
5
Connect the Power Cord to the AC Adapter.
(AP-V14E only)
6
Plug the AC Adapter into an AC outlet. The
POWER/CHARGE lamp on the camcorder
blinks to indicate charging has started.
7
When the POWER/CHARGE lamp goes out,
charging is finished. Unplug the AC Adapter
from the AC outlet. Disconnect the AC Adapter
from the camcorder.
PUSH
BATT.
POWER/
CHARGE
lamp
Power
switch
)
To detach the battery pack
Slide the battery pack upward while pressing
PUSH BATT. to detach it.
Battery pack
BN-VF707U*
BN-VF714U
BN-VF733U
* Provided
NOTES:
This product includes patented and other
proprietary technology and will operate only
with JVC Data Battery. Use the JVC BN-
VF707U/VF714U/VF733U battery packs. Using
generic non-JVC batteries can cause damage
to the internal charging circuitry.
If the protective cap is attached to the battery
pack, remove it first.
During charging, the camcorder cannot be
operated.
Charging is not possible if the wrong type of
battery is used.
When charging the battery pack for the first time
or after a long storage period, the POWER/
CHARGE lamp may not light. In this case, remove
the battery pack from the camcorder, then try
charging again.
If the battery operation time remains extremely
short even after having been fully charged, the
battery is worn out and needs to be replaced.
Please purchase a new one.
Since the AC Adapter processes electricity
internally, it becomes warm during use. Be sure to
use it only in well-ventilated areas.
Using the optional AA-VF7 Battery Charger, you
can charge the BN-VF707U/VF714U/VF733U
battery pack without the camcorder.
After 5 minutes has elapsed in Record-Standby
mode with the cassette inserted, and no operation
is performed, ("PAUSE" indicator may not appear),
the camcorder will automatically turn off its power
supplied from the AC Adapter. In this case, the
battery charge starts if the battery is attached to
the camcorder.
Charging time
Approx. 1 hr. 30 min.
Approx. 2 hrs. 40 min.
Approx. 5 hrs. 40 min.