Table of Contents
Advertisement
8) D_LED1/D_LED2 (Digital LED Strip Headers)
The headers can be used to connect a standard 5050 digital LED strip, with maximum power rating of
2A (12V or 5V) and maximum length of 5m or maximum number of 300 LEDs.
1
1
D_LED1
D_LED2
Digital LED Strip
1
For how to turn on/off the lights of the LED strip, refer to the instructions on in Chapter 2, "BIOS
Setup," "Peripherals."
Before installing the devices, be sure to turn off the devices and your computer. Unplug the power
cord from the power outlet to prevent damage to the devices.
9) DLED_V_SW1/DLED_V_SW2 (Digital LED Strip Power Select Jumpers)
The jumpers allow you to select the supply voltage of the D_LED1 and D_LED2 headers. Be sure to
verify the voltage requirements of your digital LED strip and set the correct voltage with this jumper before
connection. Incorrect connection may lead to the damage of the LED strip.
1-2: 5V
1
2-3: 12V
1
DLED_V_SW1
10) SATA3 0/1/2/3/4/5 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The Intel
4
SATA3
5
1
7
1
7
To enable hot-plugging for the SATA ports, refer to Chapter 2, "BIOS Setup," "Peripherals\SATA
Pin No.
1
V
2
D
3
G
Connect your digital LED strip to the header. There are 12V and 5V digital
LED strips. Be sure to verify the voltage requirements of your digital LED
strips and set the DLED_V_SW1 and DLED_V_SW2 jumpers accordingly.
The power pin (marked with a triangle on the plug) of the LED strip must
be connected to Pin 1 of the digital LED strip header. Incorrect connection
may lead to the damage of the LED strip.
1-2: 5V
1
2-3: 12V
1
DLED_V_SW2
3 1
SATA3
2 0
7
1
7
1
- 17 -
®
Chipset supports
Pin No.
1
GND
2
TXP
3
TXN
4
GND
5
RXN
6
RXP
7
GND
Hide quick links:
Advertisement
Table of Contents
