Table of Contents
Advertisement
All manuals and user guides at all-guides.com
Canada Department of Communication (DOC)
Notice
Telephone Connection
The Canadian Department of Communications label identifies
certified equipment. This certification means that the equipment
meets certain telecommunications network protective,
operational and safety requirements. The department does not
guarantee the equipment will operate to the user’s satisfaction.
Before installing this equipment, the user should ensure it is
permissible to connect it to the facilities of the local
communications company. The equipment must be installed
using an acceptable method of connection. In some cases, the
company’s inside wiring associated with a single line individual
service may be extended by means of a certified connector
assembly (telephone extension cord). The customer should be
aware that compliance with the above conditions may not
prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized
Canadian maintenance facility designated by the supplier. Any
repairs or alterations made by the user to this equipment, or
equipment malfunctions may give the telecommunications
company cause to request that the user disconnect the
equipment.
The user should ensure, for their own protection, that the
electrical ground connections of the power utility, telephone
lines and internal metallic water pipe systems, if present, are
connected together. This precaution may be particularly
important in rural areas.
Warning:
Users should not attempt to make such connections
themselves, but should contact the appropriate electric inspection
authority or electrician, as appropriate.
Avertissement :
L’utilisateur ne devrait pas tenter de faire ces
connexions lui-même mais devrait utiliser les services de
l’organisme approprié d’inspection des installations électriques ou
d’un électricien, selon le cas.
Warning:
The Load Number .9 assigned to each terminal
device denotes the percentage of the total load to be connected to
a telephone loop; this is used by the device to prevent overloading.
The termination on a loop may consist of any combination of
devices, subject only to the requirement that the sum of the Load
Numbers does not exceed 100.
DOC Statement (Canada only)
This Class B digital apparatus meets all requirements of the
Canadian Interference-Causing Equipment Regulations.
Cet appareil numerique de la classe B respecte toutes les
exigences du Reglement sur le materiel brouilleur du Canada.
Regulatory and Safety Information
65
Advertisement
Table of Contents
