Tam Voice Prompt Download; Check Procedure (Handset); Preparation; Equipment Required - Panasonic KX-TCD420GS Service Manual

1. Open a window of MS-DOS mode from the start-up menu.
2. Change a directory to the one with "RTX_COM" contained.
3. Type "SET RTX_COM=1" from the keyboard (when COM port 1 is used
for the connection).
4. Type "doskey".
Note:
See the table below for frequently used commands.
Command name
rdeeprom Read the data of EEPROM
readid Read ID (RFPI)
writeid Write ID (RFPI)
setfreq adjust Frequency of RFIC
hookoff off-hook mode on Base
hookon on-hook mode on Base
Getchk Read checksum
Wreeprom write eeprom
InitBsPIN.bat Initial Base PIN to "0000"

12.3. TAM Voice Prompt Download

1. Connect the parallel cable from the VOICE PROMPT DOWN LOADER
to TP101, TP102, TP103, TP104 and TP105.
2. Connect the serial cable from the PROM DOWN LOADER to J103, J104
and J105 of base P.C.B.
3. Switch on the 6V supply.
4. Invoke "vploadenable" batch file from the PC
5. Invoke "go" batch file from the PC.

13. CHECK PROCEDURE (HANDSET)

13.1. Preparation

13.1.1. Equipment Required

- DECT tester: Rohde & Schwarz, CMD 60 is recommended.
- Frequency counter: it must be precise to be able to measure 1Hz
Function
Type "rdeeprom 00 00 FF", and the data
from address "00 00" to "FF" is read out.
Type "readid", and the registered ID is
read out.
Type "writeid 00 18 E0 0E 98", and the
ID "0018 E0 0E 98" is written.
Type "setfreq nn nn".
Type "hookoff".
Type "hookon".
Type "getchk".
Type "wreeprom 01 23 45". "01 23" is
address and "45" is data to be written.
Type "initBsPIN"
Example
38