Honeywell S7999D1048 Manual page 20

S7999D1048 COMBUSTION SYSTEM OPERATOR INTERFACE DISPLAY
corner is a camera icon. When the camera icon is visible, a
snapshot can be captured of that screen. The Screen
Snapshots are available from the Display Diagnostics page.
To access the Display Diagnostic page; from the Home Page
touch the "Setup" button which will bring up the Setup Page.
Next touch the "Display Diagnostics" button to access the
Display Diagnostic page.
Fig. 35. Diagnostics page.
At the top of the screen (below the blue header bar) is the
application software version number and build number. Also
displayed is the available memory for data storage, such as
trend data.
Next USB status is provided. If a USB memory stick has been
inserted into the USB port, the status will indicate the memory
is connected and available memory space on the memory
stick.
Below the USB status is information about the Com ports (1
and 2). Receive and transmit data is provided. There is blinking
green simulated "LED" icons to indicate transmitted and
received data. Also provided is byte count, packet count and
the rate.
The "Pause", "Resume" and "Clear" buttons can be used stop
logging the information, resume logging the information and
clearing the information.
Touching the red "Pause" button stops data logging. When the
"Pause" button is touched, it turns to a green "Resume" button.
When the "Resume" button is touched, the data logging is
resumed. Touching the gray "Clear" button resets the counters
to zero.
At the bottom of the screen are buttons for screen calibration,
audio test, video test, screen snapshot and display reset.
1. Calibrate Screen
This function allows the user to calibrate the screen to
insure the accuracy of touch target to the image on the dis-
play. Touching "Calibrate Screen" button brings a screen
with a calibration target that will move around the screen (5
different points). Using a small stylus or pointer, carefully
65-0321—01
touch the center of the target. (Instructions are provided at
the top of the screen). Once the screen has been calibrated
the new setting will be automatically saved. Touch anywhere
on the blank screen to exit the screen calibration functions.
Fig. 36. Calibrate screen.
2. Audio Test
Touch the "Audio Test Off" button to activate the audio test
the S7999D speaker. When the audio test has been started,
the button will read "Audio Test On". Touch the button again
to turn the audio test off.
3. Video Test
Touch the "Video Test" button to activate the video test.
Follow the instructions on the video test page
Fig. 37. Video test screen.
4. Screen Snapshot
Touching the "Screen Snapshot" button allows the user to
access the Screen Snapshot List screen. From this screen,
the user can view, rename, copy to USB memory stick and
delete saved snapshots. The snapshot list is limited to 16
images. Save the snapshots to a USB memory stick and
then delete the snapshot from the list to be able to add addi-
tional snapshots.
20