Speaker Setup - Integra DTR-5.1 Instruction Manual

Speaker setup

Follow the steps below before you start operating the unit.
1
SP/SYS
Setup
Enter
2
Enter
Preset/Mode ADJ
Down Up
3
Preset/Mode ADJ
Down Up
14
Dimmer
Display
Enter
Enter
or
Enter button
SP SYS/Setup button
SP/SYS
Master Volume
Setup CH Level
Mode
Preset/Mode ADJ √/® button
Setting the CONFIG parameters
Set whether a speaker is used or not, and set the size of
the connected speakers.
1. Press the buttons in the following sequence to display
"CONFIG SETUP ."
2. Set whether a subwoofer is used or not.
When you press the Enter button while "CONFIG
SETUP" is displayed, the current setting ("SUBWOOFER
YES" or "NO") appears. Press the Preset/Mode
ADJ √/® buttons to select "YES" or "NO."
YES: When the subwoofer is connected.
NO: When the subwoofer is not connected.
Select whichever appropriate and press the Enter
button.
3. Select the size of the front speakers.
If you have set the subwoofer parameter to "NO" in
step 2, proceed to step 4. (At this time, the front
speaker parameter automatically sets to LARGE.)
Pressing the Preset/Mode ADJ √/® buttons toggles
between "LARGE" and "SMALL."
LARGE: When large speakers are used as the front
speakers.
SMALL: When small speakers are used as the front
speakers.
Select whichever appropriate and press the Enter
button.