Removing The Input Module - Barco iCon H250 Installation Manual

Image 4-6
PMP flipped over
4.2

Removing the input module

Necessary tools
Phillips screwdriver Ph1 — long model
How to remove the input module?
1. Remove the pixel map processor (PMP) — See the concerning chapter.
2. Loosen the two screws fixing the input module (use a long screwdriver).
Image 4-7
Fixing screws of the input box
3. Slightly lift the input module and disconnect the power connector
- J419 (6 wires): power from the power box (connector 6)
Image 4-8
4. Lift the input module to remove it
R59770246 DVI HDCP INPUT KIT 28/04/2008
4. Installation in the iCon H250/H400/H500 and in the iD H250/H500
15