Table of Contents
Advertisement
Troubleshooting guide
Symptom
No power
Disc cannot be loaded.
Disc cannot be read.
(LCD shows
"ERROR2")
SD/MMC cannot be read.
(LCD shows
"ERROR8")
USB cannot be read.
(LCD shows "S-STOP")
No sound
The buttons do not work. The built-in microcomputer is not
Cause
The car ignition is not on.
The fuse is blown.
Presence of disc inside the player.
Inserting the disc in upside down.
Compact disc is extremely dirty or
defective.
Temperature inside the car is too
high.
Metal interface is rusty, extremely
dirty or defective.
Metal interface is rusty, extremely
dirty or defective.
Volume is in minimum.
Wiring is not properly connected.
operating properly due to noise.
Front panel is not properly fix into
its place.
If the power supply is properly connected
to the car accessory switch the ignition
key to "ACC".
Replace the fuse.
Remove the disc in the player then put a
new upward.
Insert the compact disc with the label
facing upward.
Clean the disc or try to play a new one.
Cool off until the ambient temperature
returns to normal.
Clean the metal interface or try to play a
new one.
Clean the metal interface or try to play a
new one.
Adjust volume to a desired level.
Check wiring connection.
Press RESET button.
Reinstall the front panel.
36
Solution
Advertisement
Table of Contents
