Setting The Remote Transmitter And Receiver - Hunter 45062-01 Owner's Manual And Installation Manual

4 • Setting the Remote Transmitter and Receiver
Setting DIP switches
When two or more fans are located near each other, you may desire
to have the receiver/transmitter for each fan set to a different code,
so that the operation of one fan does not affect the operation of the
other fans.
The DIP switches for the receiver are located on the flat surface of
the receiver. The DIP switches for the transmitter are in the battery
compartment.
4-1 . IMPORTANT! Before you change the DIP switch settings, make
sure the battery is not connected to the transmitter.
Change the position of the DIP switches in the remote transmitter
and the receiver. Make sure that the DIP switches match in
the remote receiver and transmitter. If they don't match, the
transmitter will not function.
4-2. There is a toggle switch beside the DIP switches on the transmitter.
Move the toggle switch toward the side that reads "CFL" if you are
going to operate the fan with CFL bulbs. Move the switch to the
"INC" side if you are going to use incandescent bulbs.
4-3. Install the included 9-volt battery into the transmitter.
CAUTION: The remote control device complies with part 15 of the FCC rules.
Changes or modifications not expressly approved by Hunter Fan Company could void
your authority to operate this equipment.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may
cause undesired operation.
WARNING: Use only the Hunter Fan speed control supplied with this fan.
4-4. Raise the fan and align the slots in the canopy with the hooks
on the ceiling plate.
Note: To hang the fan, you must tilt the canopy to an almost
vertical position so that the canopy slots sit on the ceiling
plate hooks.
7
45062-01 • 07/01/09 • Hunter Fan Company
Receiver DIP
switches
Transmitter DIP switches
Example DIP Switch Settings
Receiver 1 Receiver 2
DIP Switches
DIP Switches
Dip Switches Dip Switches
Set to 01110 Set to 01001
Set to 0100
Set to 0111
Transmitter 1 Transmitter 2
DIP Switches DIP Switches
Dip Switches Dip Switches
Set to 0111 Set to 01110 Set to 0100 Set to 01001