Assembling And Hanging The Fan - Hunter 42797-01 Owner's Manual And Installation Manual

Steps 4-1 – 4-2
Steps 4-4 – 4-5
Low Profile Washer
Low Profile Screw
Step 4-6
4 • Assembling and Hanging the Fan
You can assemble your fan for standard mounting (steps 4-1 – 4-2)
or for low profile mounting (steps 4-3 – 4-5). Note: For low profile
mounting, the downrod is replaced with the low profile washer.
Downrod
4-1. To assemble fan to hang down from a flat or angled ceiling, insert
the downrod through the canopy. Feed the wires from the fan
through the downrod.
4-2. Loosen the square head set screw on the adapter to install the
Canopy
pipe and ball assembly. Note: When the pipe and ball assembly
is fully installed, 2-3 threads on the pipe will still be visible; this is
normal. Securely retighten the set screw with a wrench or pliers.
Skip to Step 4-6.
CAUTION: The adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
4-3. Remove the set screw from the adapter.
4-4. Place the low profile washer (lip down) into the canopy. Be sure
the green ground wire is pointing up toward the ceiling.
4-5. Align the holes in the washer with the holes in the adapter.
Assemble securely with three low profile screws.
Note: Before hanging the fan, align and engage the two tabs from the
bottom of the canopy and the two grooves in the hanger ball.
4-6. Raise the fan and place the hook on the ceiling plate through the
round hole in the rim.
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
Round
Hole
7
42797-01 • 11/13/08 • Hunter Fan Company