Advertisement
Congratulations!
In purchasing the Hilti D-LP 30 (LP 20) / DS-TS 30 wall saw system you have acquired a quality product that provides
the highest level of performance, safety and reliability. Uncompromising quality assurance during its manufacture
ensures that the system will have a long service life.
The system's modular design, quick and convenient installation principle and semi-automatic advance (which func-
tions independently of the material being cut) provide advantages that make it a pleasure to cut through steel-rein-
forced concrete, i.e. walls, floors and ceilings with a thickness of up to 73 cm, while guaranteeing high cost efficiency
and economy.
These operating instructions are intended for the use of concrete cutting service contractors and their experienced
personnel, referred to in the following paragraphs as «the operator». Before operating the D-LP 30 (LP 20) / DS-TS 30
wall saw system, the operator must read and understand these operating instructions and receive training from a Hilti
specialist. This will ensure that the system can be operated efficiently, economically and safely.
We would like to wish you every success in your work and thank you for placing your confidence in Hilti products.
Contents
2. Warnings concerning fastening, setting up and operating the system
4. The modular hydraulic saw system
6. Blade speeds, gear selection, sawing procedure
9. Hydraulic unit - operating modes, connections, operation, care and maintenance
10. Checks, operation, the sawing procedure using hydraulic saw systems
13. Fault finding and elimination of faults
³
D-LP 30 (LP 20) hydraulic unit
·
DS-CB 3 / CB 4 remote control unit
»
DS-RF rail support
¿
D-R 200 L rail (length 200 cm)
´
DS-ES end stop
²
DS-TS 30 saw head
¶
Water valve
º
Water supply hose
¾
DS-B saw blade (type BC, LC)
µ
DS-BG blade guard
¸
D-PH 34-10 hydraulic hoses (
¹
D-FH 4/14-10 hydraulic control hoses (
2
")
3
/
4
")
1
/
4
¸
º ¶
¿
µ
¹
·
¾
³
Advertisement
