Inspect/Replace; Engine Air Cleaner Service Indicator - Inspect; Engine Air Cleaner Element (Single Element) - Inspect/Replace - Perkins 1103 Operation And Maintenance Manual

SEBU7833
Inspecting the Primary Air Cleaner
Elements
Illustration 39
Inspect the clean, dry primary air cleaner element.
Use a 60 watt blue light in a dark room or in a similar
facility. Place the blue light in the primary air cleaner
element. Rotate the primary air cleaner element.
Inspect the primary air cleaner element for tears and/
or holes. Inspect the primary air cleaner element for
light that may show through the filter material. If it is
necessary in order to confirm the result, compare the
primary air cleaner element to a new primary air
cleaner element that has the same part number.
Do not use a primary air cleaner element that has any
tears and/or holes in the filter material. Do not use a
primary air cleaner element with damaged pleats,
gaskets or seals. Discard damaged primary air
cleaner elements.
Engine Air Cleaner Element
(Single Element) - Inspect/
Replace
Refer to Operation and Maintenance Manual, "Engine
Air Cleaner Service Indicator-Inspect".
NOTICE
Never run the engine without an air cleaner element
installed. Never run the engine with a damaged air
cleaner element. Do not use air cleaner elements with
damaged pleats, gaskets or seals. Dirt entering the
engine causes premature wear and damage to en-
gine components. Air cleaner elements help to pre-
vent airborne debris from entering the air inlet.

Engine Air Cleaner Element (Single Element) - Inspect/Replace

Never service the air cleaner element with the engine
running since this will allow dirt to enter the engine.
A wide variety of air cleaners may be installed for use
with this engine. Consult the OEM information for the
correct procedure to replace the air cleaner.
Engine Air Cleaner Service
Indicator - Inspect
Some engines may be equipped with a different
service indicator.
g00281693
Some engines are equipped with a differential gauge
for inlet air pressure. The differential gauge for inlet
air pressure displays the difference in the pressure
that is measured before the air cleaner element and
the pressure that is measured after the air cleaner
element. As the air cleaner element becomes dirty,
the pressure differential rises. If your engine is
equipped with a different type of service indicator,
follow the OEM recommendations in order to service
the air cleaner service indicator.
The service indicator may be mounted on the air
cleaner element or in a remote location.
i02152042
Illustration 40
Typical service indicator
Observe the service indicator. The air cleaner
element should be cleaned or the air cleaner element
should be replaced when one of the following
conditions occur:
• The yellow diaphragm enters the red zone.
• The red piston locks in the visible position.
Test the Service Indicator
Service indicators are important instruments.
Refill Capacities
NOTICE
i01909507
g00103777
65