Table of Contents
Advertisement
Installation
The FortiSandbox unit can be placed on a
mounted in any standard
19 inch rack
Please also read "Cautions and Warnings" on page <?> prior to installing your device.
Caution:
The rack must be
stabilized
Failure to stabilize may cause the rack to
Electrostatic discharge
(ESD) can damage your Fortinet equipment.
To avoid personal
injury
or
damage
people install the unit into the rack.
Do not place
heavy objects
on the unit.
Rack Precautions
•
Ensure the
leveling jacks
on the bottom of the rack are
the full weight of the rack resting on the jacks.
•
For single rack installation,
stabilizers
•
For multiple rack installations, the racks should be
•
Ensure the rack is
stable
before extending a component from the rack.
•
Only extend
one component
at a time; extending
cause the rack to become unstable.
10
flat surface
using the provided rubber feet, or
unit with the provided mounting rails.
before sliding the unit out for servicing.
tip
over.
to the unit, it is recommended that
two or more
fully extended
to the floor with
should be attached to the rack.
coupled
together.
two or more
simultaneously may
Rack Rail Parts
The
rail assembly
consists of
two
parts:
•
Outer
rail: connects to the rack
•
Inner
rail: connects to the device
The
inner rail
has a
locking tab
that locks the device into place when it is installed and
pushed into the rack. This
prevents
the device from
device is being worked on.
There are
four steps
to install the device into the rack:
1.
Disassemble
the rail assembly
2. Attach the
inner rails
to the device
3. Install the
outer rails
on a rack
4. Install the device into
the rack
Disassemble the rail assembly
1. Identify the left and right
rail
assemblies.
2.
Pull out
the inner rail until it is fully extended.
3. Push the
white locking tab
to release the inner rail.
4. Remove the
inner rail
from the
outer
5. Repeat steps 2 - 4 for the remaining rail assembly.
Attach the inner rails to the device
1. Ensure that the
right and left rails
are correctly identified.
2. Place the
inner rail
against the side of the device and ensure that the screw
aligned.
3. Secure the rail to the device using
five
4. Attach the
sliding rail handle
to the device using
screws.
5. Repeat steps 2 - 3 for the remaining inner rail.
sliding
fully out of the rack when the
rail.
holes
of the provided
M4 Waffle Head
screws.
three
of the provided
M4 Flat Head
are
11
Advertisement
Table of Contents
