ResMed S9 User Manual page 5

English
Thank you for choosing the ResMed S9 Embletta adapter. Use the S9 Embletta
adapter to connect an S9 device with an Embletta
Please read the entire guide before using this device.
S9 Embletta adapter
Refer to illustration A.
Release button
1.
2. Serial cable connector port
3. Adapter connector
4. Adapter clip
Setup
1. Disconnect the S9 device from the power outlet.
2. Align the S9 Embletta adapter clips with their corresponding sockets and push
the adapter onto the S9 device [see illustrations C and D]. Ensure the adapter
clips click into place.
3. Connect the Embletta interface cable to the serial socket.
4. Reconnect the S9 device to the power outlet.
Refer to the Embletta user instructions for information about setting up and using
the Embletta PDS.
Portable Diagnostic System (PDS).
™
Rear panel of S9 device
Refer to illustration B.
DC Power inlet
1.
2. Adapter clip socket
3. Module/Adapter port
4. SD card slot
5. Alarm (Bilevel alarmed devices only)
1
English