Settings - IKEA ENASTAENDE Manual

ENGLISH
What to do if you want to stop using multi-
tablets
Before you start to use detergent, salt and
rinse aid separately do the following
procedure.
1. Deactivate the Multitab option.
2. Set the highest level of the water
softener.
3. Make sure that the salt and rinse aid
containers are full.
4. Start the shortest programme with a
rinsing phase. Do not add detergent
and do not load the baskets.
5. When the programme is completed,
adjust the water softener according to
the water hardness in your area.
6. Adjust the released quantity of rinse aid.
EnergySaver
This option decreases the temperature of
the last rinsing phase and consequently also

Settings

Programme selection mode and user
mode
When the appliance is in programme
selection mode it is possible to set a
programme and to enter the user mode.
In user mode, the following settings can
be changed:
• The level of the water softener according
to the water hardness.
• The activation or the deactivation of the
acoustic signal for end of programme.
• The activation of the rinse aid dispenser
when you want to use the Multitab
option and the rinse aid together.
These settings will be saved until you
change them again.
the energy consumption (approximately
-25%).
Dishes can still be wet once the programme
is completed.
The duration of the programme will be
shorter.
How to activate EnergySaver
Press , the related indicator comes on.
If the option is not applicable to the
programme, the related indicator does not
come on or it flashes quickly for a few
seconds and then goes off.
The display shows the updated programme
duration.
The EnergySaver option is applicable for all
programmes except for programme number
6, the Rinse programme.
How to set the programme selection mode
The appliance is in programme selection
mode when the display shows 2 horizontal
status bars.
When you activate the appliance, usually it
is in programme selection mode. However,
if this does not happen, you can set the
programme selection mode in the following
way:
Press and hold RESET until the appliance is
in programme selection mode.
The water softener
The water softener removes minerals from
the water supply, which would have a
detrimental effect on the washing results
and on the appliance.
10