IKEA ENASTAENDE Manual page 15

ENGLISH
5
If the programme
has a prewash
phase, put a small
quantity of
detergent in on the
inner part of the
appliance door.
Setting and starting a programme
The Auto Off function
This function decreases energy consumption
by automatically deactivating the
appliance when it is not operating.
The function comes into operation:
• 5 minutes after the completion of the
programme.
• After 5 minutes if the programme has not
started.
Starting a programme
1. Keep the appliance door ajar.
2. Press the on/off button to activate the
appliance. Make sure that the
appliance is in programme selection
mode.
3. Press or
the display shows the number of the
programme you want to start. The
display will show the programme
number for approximately 3 seconds
and then show the programme duration.
4. Set the applicable options.
5. Close the appliance door to start the
programme.
repeatedly until
Starting a programme with delay start
1. Set a programme.
2. Press repeatedly until the display
shows the delay time you want to set
(from 1 to 24 hours).
The delay indicator comes on.
3. Close the appliance door to start the
countdown.
While a countdown is running it is possible
to increase the delay time and to change
the selection of the options but not to
change he selection of the programme.
When the countdown is completed, the
programme starts.
Opening the door while the appliance
operates
If you open the door while a programme is
running, the appliance stops. When you
close the door, the appliance continues from
the point of interruption.
Cancelling the delay start while the
countdown operates
When you cancel the delay start you have
to set the programme and options again.
Press and hold RESET until the appliance is
in programme selection mode.
Cancelling the programme
Press and hold RESET until the appliance is
in programme selection mode.
Make sure that there is detergent in the
detergent dispenser before you start a new
programme.
15