Specifications - Sony DVS-V3232M Operation Manual

Specifications

General
Power requirements 100 to 240 V AC, 50/60 Hz
Current consumption 1.6 to 0.9 A (with optional boards
fully installed)
Peak inrush current
(1) Power ON, current probe method:
20 A (240 V), 15 A (100 V)
(2) Hot switching inrush current, measured in
accordance with European standard EN55103-1:
15 A (230 V)
Appel de courant de crête
(1) Mise sous tension (ON), méthode de sondage
du courant: 20 A (240 V), 15 A (100 V)
(2) Mesuré conformément à la norme européenne
EN55103-1: 15 A (230 V)
Spitzenstrom
(1) Einschaltstrom, Stromsonde:
20 A (240 V), 15 A (100 V)
(2) Gemessen in EN55103-1:
15 A (230 V)
Operating temperature 5°C to 40°C (41°F to 104°F)
Operating humidity 10% to 90% (no condensation)
Ideal temperature 10°C to 35°C (50°F to 95°F)
Mass 26 kg (57 lb 5 oz) (with all
optional boards installed)
424 × 221 × 550 mm (w/h/d)
Dimensions
3
(16
Video signals
Data transfer method Scrambled NRZI
Data transfer rate 4:2:2 component digital signal:
270 Mbps
4 fsc composite digital signal
NTSC: 143 Mbps
PAL: 177 Mbps
Component digital signal:
360 Mbps, 540 Mbps
Signal amplitude 0.8 Vp-p ±10%
Signal transfer distance
For data transfer rates 143, 177,
270, 360 Mbps: 200 m max.
(when using a BELDEN 8281
75-ohm coaxial cable or
equivalent)
For data transfer rates 540 Mbps:
150 m max. (when using a
BELDEN 8281 75-ohm coaxial
cable or equivalent)
× 8 × 21
3 3
/ / / inches)
4 4 4
Input/output connectors
Reference video signal input
BNC type (×2), high impedance,
analog video signal, with loop-
through output
Remote control connectors
REMOTE 1 A, B, C and REMOTE 4
S-BUS BNC type (×4),
47 kilohm input
Data transfer method: BI-PHASE
SPACE
Data transfer rate: 312.5 kbps
Signal transfer distance: 500 m
(when using a BELDEN 8281
75-ohm coaxial cable or
equivalent)
REMOTE 2 A and B
Complies with RS-422A signal
standard (changeable upon
S-BUS command)
D-sub 9-pin (×2), 100 ohm/
10 kilohm
Data transfer rate: 38.4 kbps
REMOTE 3 Complies with RS-232C signal
standard for connecting a
control terminal
D-sub 25-pin (fixed with M2.6
screws) (×1)
Terminal 9600 bps, DTR control
8-bit, No parity, No check,
1 stop bit
ISR 9600 bps
7-bit, ODD parity, 1 stop bit
AC power input 3-pin AC IN connector (×2)
Accessories supplied
Operation manual (1)
Installation manual (1)
Maintenance manual Part 1 (1)
75-ohm terminators (3)
T-bridge (B) (1)
D-sub connector screws (2)
17 (E)