Toro Groundsmaster 4500-D Installation Instructions Manual page 3

Figure 2
1. Bolts
2. Chassis bracket
3. Divider tube
4. Nut
5. Clamp
3. Remove the rear end of the pressure hose from
the fitting in the hydraulic pump, and remove the
pressure hose (Figure 1
4. Temporarily cap the pump and the divider tube.
Note:
Discard the original pressure hose.
g021282
6. Tube bracket
7. Pressure hose
8. Up
9. Forward
and Figure 2).
Removing the Cross Tube
1. Align the drain pan below the rear-traction
manifold.
2. Remove the tube nut for the cross tube from the
fitting in the rear-traction manifold
3. Remove the tube nut for the filter tube from the
fitting in the cross tube, and remove the cross
tube (Figure 1).
Note:
Discard the cross tube.
4. Temporarily cap the fitting in the rear-traction
manifold.
Removing the Tube Bracket and
the Clamp
1. Remove the bolt and the nut that secure the
divider tube to the tube bracket, and remove the
clamp (Figure
2. Remove the 2 bolts and the 2 nuts that secure
the tube bracket to the chassis bracket
2).
Note:
Discard the tube bracket and the clamp.
Removing the Divider Tube
1. Remove the tube nut for the rear-traction tube
from the fitting of the divider tube.
2. Remove the tube nut of the divider tube from
the T-fitting in the front-left traction motor, and
remove the tube from the machine
Note:
Discard the divider tube.
3
(Figure
2).
(Figure
1).
(Figure
1).