Advertisement
Location and Function of Parts
!¡ DISPLAY switch
The functions of the DISPLAY switch are as follows:
ON: Text and messages describing the camera
settings and operating status may be displayed on
the viewfinder screen.
OFF: Status messages will not appear on the
viewfinder screen.
MENU: Menus for camera settings will be displayed
on the viewfinder screen.
!™ MENU SELECT switch
The functions of the MENU SELECT switch are as
follows:
ENTER: Confirm the menu or page selected using
the MENU SELECT control !£, or confirm
setting values.
CANCEL: Cancel menu setting values or return to
page select mode or the top menu.
!£ MENU SELECT control
Used to select menu items or change setting values in
the menus displayed on the viewfinder screen.
!¢ Back tally lamp
Lights red when the red tally signal is supplied. When
the CALL button on the MSU-700 Master Setup Unit
or the RCP-700 series Remote Control Panel is
pressed, the lamp lights if previously off or goes off if
previously on. The brightness of the lamp may be
adjusted using a control provided in the camera.
Attach a supplied number plate (0 through 9) to
display the camera number. Lights green when the
green tally signal is supplied.
For more information on adjusting the lamp brightness or
attaching a number plate, contact a Sony service or sales
representative.
!∞ CALL button
• Press to call the operator of the HDCU-700A Camera
Control Unit, the MSU-700 Master Setup Unit, or the
RCP-700 series Remote Control Panel. When
pressed, the camera's red tally lamp will light up if
previously off, and turn off if previously on. The
CALL button on the MSU-700 Master Setup Unit or
RCP-700 series Remote Contrn Panel will light up,
and their buzzer will sound.
• When the CALL button on the RCP-700 series
Remote Control Panel or the MSU-700 is pressed,
this button will light up.
10(E)
!§ CURSOR (cursor memory) 1, 2, and 3 buttons
Store the size and position of the box cursor displayed
on the viewfinder screen.
Three different box cursor settings may be stored in
memory using buttons 1, 2, and 3. Pressing one of
these buttons will cause a cursor of the stored size to
be displayed in the stored position.
Note
When one of the CURSOR buttons is lit up, the H-
POSI, V-POSI, WIDTH, and HEIGHT buttons will be
disabled.
!¶ CURSOR ON button
When this button is pressed, the button will light up
and the box cursor will be displayed on the viewfinder
screen. When the button is pressed again, the light
will go off and the box cursor will disappear.
!• CURSOR STORE button
Press this button to store the size and position of the
box cursor in memory.
Note
If the CURSOR ON button !¶ is not lit, box cursor
information will not be stored.
!ª RETURN SELECT knob 1
This knob selects from the four return signals from the
CCU. By pressing in the RET 1 button @¡, you can
view the selected return video signal in the viewfinder.
The output signal from the TEST OUT connector also
switches to this signal.
@º RETURN SELECT knob 2
This knob selects from the four return signals from the
CCU. By pressing in the RET 2 button @™, you can
view the selected return video signal in the viewfinder.
The output signal from the TEST OUT connector also
switches to this signal.
@¡ RET 1 button
By pressing in this button, you can view the return
video signal selected by the RETURN SELECT knob
1 !ª, in the viewfinder. The output signal from the
TEST OUT connector also switches to this signal.
Pressing this button again will switch the viewfinder
screen display and MONITOR output back to the
camera's video signal.
Advertisement
