Advertisement
1 Video signal select buttons
Selects the video output signal (R, G, or B) to the
viewfinder. The video output signal to the monitor
connected to the TEST OUT connector will also be
selected.
• The R, G, and B buttons may be pressed individually
or in combination. The signal corresponding to each
pressed button will be output. When two buttons are
pressed, the output of will consist of those two
signals mixed together.
• When all three buttons are pressed, the output to the
viewfinder and monitor will be the Y signal.
• When no button is pressed, the output to the
viewfinder and monitor will be the Y signal.
2 POWER indicator
Lights up or goes off as follows to indicate the power
supply status:
Green: Power is being supplied to the HDC-700A.
Red: The CAM PW button of the MSU-700 Master
Setup Unit or RCP-700 series Remote Contorol
Panel is set to OFF.
Yellow: Power is being supplied to the HDC-700A,
but the VF PW button of the MSU-700 Master
Setup Unit or RCP-700 series Remote Contorol
Panel is set to OFF, and power is not being
supplied to the viewfinder.
Off: Power is not being supplied to the HDC-700A.
3 ND filter selector
When the FILTER LOCAL button 5 is lit up, this
selector may be used to select an ND filter.
Selector position
Selected filter
1
Clear
2
1/4ND
3
1/8ND
4
1/16ND
5
1/64ND
4 CC (color temperature conversion) filter
selector
When the FILTER LOCAL button 5 is lit up, this
selector may be used to select a color temperature
conversion filter appropriate to the light source
illuminating the subject.
Selector position
Selected filter
A
Cross filter
B
3200K (clear)
C
4300K
D
6300K
E
8000K
5 FILTER LOCAL (filter local control) button
Pressing this button enables selecting of a color
temperature conversion filter or ND filter using the CC
filter selector 4 and ND filter selector 3. Pressing
the button again gives control of the filters to the
MSU-700 Master Setup Unit or RCP-700 series
Remote Control Panel.
6 UP TALLY switch
Sets whether or not the camera's Up Tally lamp will
light when the camera receives a red tally signal.
ON: The Up Tally lamp will light.
OFF: The Up Tally lamp will not light.
7 VF (viewfinder) SCAN switch
Controls the viewfinder screen display.
16:9: Sets the viewfinder display to 16:9 aspect ratio.
4:3: Sets the viewfinder display to 4:3 aspect ratio.
8 4:3 MARKER switch
Controls the display of the 4:3 marker as follows:
ON (
): Areas outside the 4:3 aspect ratio area will
be darkened.
ON (
): The 4:3 marker (white lines) will be
displayed.
OFF: The 4:3 marker will not be displayed.
9 CENTER MARKER switch
Controls the display of the center marker as follows:
ON: A marker indicating the center of the picture
area will be displayed on the viewfinder screen.
The position of the center marker may be adjusted
for the lens being used. The adjusted position
may be stored in a lens file.
For more information, contact a Sony service or sales
representative.
OFF: The center marker will not be displayed.
0 SAFETY ZONE switch
Controls the display of the safety zone marker as
follows:
ON: A frame marking 90% of the picture area (the
safety zone) will be displayed on the viewfinder
screen.
Using the Marker Settings page in the Operation
menu, the size of the displayed frame may also be
set to 80%, 92.5%, or 95% of the picture area.
OFF: The safety zone will not be displayed.
9(E)
Advertisement
