Advertisement
use. Follow the instructions
provided in this book.
• The AquaStation™ Purifier must
be used only with the Breville
filter supplied or replacement
product code LWA063.
• This appliance has been
designed specifically for the
purpose of filtering drinking
quality water only. Under no
circumstances should this
appliance be used to heat any
other liquids.
• Do not place the appliance
near the edge of a bench or
table during operation. Ensure
that the surface is level, clean
and free of water and other
substances.
• Do not operate the appliance on
a sink drain board.
• Never immerse the appliance,
power cord or power plug in
water, or allow moisture to come
into contact with these parts.
• Do not move the appliance
while it is switched on.
• Always ensure the appliance
returns to standby mode, then
turn the power off at the power
outlet and remove the power
plug from the power outlet
before attempting to move the
appliance, when the appliance is
not in use and before cleaning
and storing.
• Do not remove the water tank
from the power base during
operation.
• If the water tank is removed
from the power base during
water dispensing, the appliance
will automatically stop.
• Always fill the water tank with
water between the minimum
(MIN) and maximum (MAX) as
marked on the water tank.
• Too little water will result in the
appliance not operating and the
Fill Tank indicator water drop
icon will turn red. Filling above
the maximum mark (MAX) may
result in water splashing from
the water tank.
• Ensure the water level is
always above the MIN level for
optimum dispensing flow rate.
• The lid should always be
correctly fitted on the water tank
except when refilling.
• Do not place the appliance
in direct sunlight. Colour
fading and discolouration
may occur when the appliance
is consistently exposed to
sunlight.
• This appliance is intended to
filter tap water only. Do not put
water of unknown quality into
the appliance. Use only cold or
room temperature water.
3
Advertisement
