Advertisement
90d
3x
MAX
MIN
3x
90d
1. Lift the water tank from the purifier, remove
the lid and set aside. Lifting by the ring,
MAX
remove the filter cartridge from the filter
90d
holder and discard any remaining water
MIN
inside the water tanks, then separate the
NEW FILTER
upper tank from the lower tank.
3x
10m
SHAKE FILTER
3x
MAX
NEW FILTER
MIN
2. Remove the new filter cartridge from
its packaging
MAX
10m
SHAKE FILTER
NOTE
MIN
It is normal for the filter to appear moist
when removed from its wrapping. This
NEW FILTER
is condensation from the hygienic steam
sterilisation process.
10m
SHAKE FILTER
NEW FILTER
10m
SHAKE FILTER
3. Immerse the filter in a bowl of tap water and
gently shake until there are no air bubbles.
1L
Soak filter in the tap water for 10 minutes.
MAX
1L
MIN
4. Once soaked, insert the filter into the filter
holder of the upper tank and push down
firmly to secure in place.
3s
MAX
MIN
1L
3s
1L
MAX
NEW FILTER
MIN
10m
MAX
SHAKE FILTER
MIN
10m
SHAKE FILTER
NOTE
Make sure the filter is tightly fitted. If the filter
NEW FILTER
is not pressed in tightly, unfiltered tap water
may flow around the filter into the lower water
NEW FILTER
tank, or the filter may float up.
10m
SHAKE FILTER
10m
SHAKE FILTER
5. Place the upper tank into the lower water
tank.
1L
1L
6. To flush and activate the new filter
MAX
cartridge, add 1L of water to the upper water
tank, allowing the water to filter through.
MIN
MAX
Remove the water tanks and discard the
collected water. Repeat this step once more
1L
MIN
so the filter is fully flushed with 2L of water
3s
before use.
1L
3s
MAX
MIN
MAX
7. Once flushed, fill the water tank with tap
MIN
water up to the MAX line.
3s
3s
8. Press and hold the START/STOP
button for 3 seconds; the purifier will beep
once and the water droplet light will stop
flashing. The filter reset has now been
completed.
11
Advertisement
