Vax ASTRATA POWER VZL-401 Instruction Manual page 8

Vax VXL 401 User Guide.qxd:VZL-401 User Guide
www.vax.co.uk
Replace dirt container
Return dirt container to cleaner. Align slot on bottom of
dirt container with tab on cleaner. Push to snap into place
(Fig.5/14)..
Fig.5/14
Regular Maintenance
Each time the dirt container is emptied, the foam filter
should be checked and when necessary, cleaned (Filter
will be discoloured after use, this will not affect the
filter's performance). Do not brush the filter. The cleaning
instructions may vary depending on the dirt conditions. In
some cases, more or less cleaning of the filter may be
required.
6. Belt or brushbar: removal
and replacement
TOOL REQUIRED: Phillips screwdriver
WARNING: to reduce the risk of injury from
!
moving parts - unplug cleaner before changing
belt or brush.
To remove belt
Lay cleaner flat and flip cleaner to expose nozzle base
(Fig.6/1).
Fig.6/1
Base should lay flat and face up. To remove nozzle guard,
use Phillips screwdriver to remove the SIX (6 ) screws.
Arrows show location of screws (Fig.6/1).
8
belt or brush bar
All manuals and user guides at all-guides.com
13/6/07 18:01 Page 8
Remove sole plate by lifting off (Fig.6/2).
Fig.6/2
Lift and remove brushbar. Dispose of old belt (Fig.6/3).
Fig.6/3
To replace belt or brushbar
Slide belt onto motor shaft (Fig.6/4).
Fig.6/4
Place new belt in area of brushbar without bristles (Fig.6/5).
Fig.6/5